MAINTENANCE & CALIBRATION
AVOID MEASUREMENT UNCERTAINTIES
Sensors and measuring devices must be calibrated regularly, as their properties and thus the measurement uncertainties can change over time due to use, ageing and environmental influences.
The measuring equipment used for calibration is traceable to national standards and is subject to internationally uniform quality assurance. We carry out maintenance and calibration of our NC joining modules worldwide.
- Maintenance of the NC joining modules
- Calibration of the force transducers
- Force balancing and issuing of a factory calibration certificate
- Worldwide service through EMG
Maintenance of the NC joining modules and calibration of the force transducers should be carried out every 12 months, unless practice demands smaller intervals due to high cycle rates or heavy stress on the NC joining modules. That’s where we rely on feedback from the customer’s quality management or the responsible persons.
WRITTEN APPOINTMENT REQUESTS
Fax: +49 (0) 29 51 / 93 883 – 29
APPOINTMENT REQUEST BY FORM
GET IN CONTACT WITH US!